FMS - VERTICAL REVISIONS Flashcards
A geographic step is entered with the desired altitude or flight level and a waypoint designation preceded by a:
A) / B) * C) # D) –
A) /
Which of the following is a type of step climb?
A) Optional B) Optimal C) Occasional D) Oscillating
B) Optimal
If the FMS will show a message of “Speed Error at Waypoint, if it predicts your speed will be:
A) 5 knots greater than the speed constraint B) 5 knots slower than the speed constraint C) 10 knots greater than the speed constraint D) Above VMO
C) 10 knots greater than the speed constraint
A speed limit entered before the top of descent is referred to as a:
A) TOD speed limit B) Top of Climb speed limit C) Cruise speed limit D) Climb speed limit
D) Climb speed limit
Which of the following is not a category of data defined by the vertical mode?
A) Temporary B) Strategic C) Tactical D) Weather
A) Temporary
To enter on optimal step point, write the desired altitude or flight level and put within:
A) ( ) B) / / C) @ @ D) [ ]
D) [ ]
The term RTA refers to:
A) Real Time of Arrival B) Reset Time of Arrival C) Reset Time of Arrival D) Required Time of Arrival
A) Real Time of Arrival
If you want to delete a speed limit on Flight Plan Page A, you clear the:
A) Pseudo-waypoint speed limit B) Max Mach limit switch C) FMS D) Speed limit in the ASEL
A) Pseudo-waypoint speed limit
How do you define a Constant Mach segment of an alternate flight plan?
A) Cannot be done B) /CM .82 C) + CM .82 D) * CM .82
A) Cannot be done
In both climb and descent below 10,000 ft., the airspeed limit always defaults to:
A) 210 knots B) 215 knots C) 250 knots D) 280 knots
C) 250 knots
When an altitude constraint is entered directly into Flight Plan A, you must enter which of the following before entering the value?
A) + B) / C) \_\_ D) @
B) /
To add an altitude constraint into the flight plan, type the altitude or flight level into the scratchpad with which of the following?
A) # B) / C) * D) No symbol
B) /
Strategic data applies to the: Ref 5
A) Specific phase of flight B) Overall flight profile C) Planned approach profile D) Fuel plan data
B) Overall flight profile
If you enter a second time constraint into a flight plan, what happens to the first time constraint?
A) FMS meets both constraints B) Recomputes the first constraint C) Deletes the first constraint D) FMS will miss both constraints
C) Deletes the first constraint
If you are entering an altitude constraint that is to be “at or above”, you should enter which symbol?
A) + B) \_\_ C) A/A D) _/A
A) +
