C/W Panel Flashcards Preview

H130T2 > C/W Panel > Flashcards

Flashcards in C/W Panel Deck (29)
Loading flashcards...
1
Q

Twist Grip

A

Turn Twist Grip to FLIGHT position

continue flight

2
Q

ENG CHIP

takeoff prohibited until Turbomeca checks are complete

A

reduce collective
land ASAP
low power approach and landing
be prepared for loss of engine power

3
Q

ENG P light

eng oil pressure low

A

check oil pressure guage
low or nil - autorotate
normal - land ASAPL

4
Q

MGB P

main GB pressure low

A

reduce Collective
LAND ASAP at nearest ldg site
max 55 min at 70 kts

5
Q

MGB TEMP

main GB oil overheating > 115C

A

airspeed to 70 KIAS
monitor CWP
if light extingishes, land ASAPL
if light remains on, land ASAP

6
Q

MGB CHIP

A

reduce collective
monitor MGB T and P
Land ASAP

7
Q

TGB CHIP

A

avoid prolonged hovering

continue flight

8
Q

HYDR + SERVO

LIMIT light may be on if LH circuit failed or during load factor maneuvers. The remaining circuit allows continued safe flight and landing.
HDY 1 LH circuit (limit may come one)
HDY 2 RH circuit

A
maintain level attitude	
avoid abrupt maneuvers	
maintain bank angle less than 30
IAS below 110 kts
Land ASAPL
9
Q

SERVO

jamming of a distributor valve on main servo unit

A

LAND ASAPL

10
Q

BATT TEMP

batt temp above max

A
BATT OFF
check U Bus Voltage 
normal - land asapl
above Umax	
Batt ON	
GEN OFF	
unnecessary eq OFF	
LAND ASAPL
11
Q

BATT

BATT comes on if the DC system is supplied with external power.

A
check BATT ON
yes	
check voltage on VEMD	
Land ASAPL
no	
turn BATT ON	
continue flight
12
Q

GENE
If the battery fails, the VEMD will go out and only the analogue NR indication will remain.
(or NR/N2 indication is lost)
Max KIAS 100 kts -2kt/1000”
GENE comes on if the DC system is supplied with external power.
Avoid autorotation, perform a shallow approach with a cautious landing.

A
check Ubus on VEMD	
Check GENE ON
If OFF: turn on
If ON: check GEN reset CB in	
Reset GEN then ON
if restored - continue flight
if not restored - GEN OFF	
unnecessary eq OFF	
monitor VEMD ubus	
Land ASAPL
13
Q

FUEL

quantity 15 minutes at MCP remaining

A

LAND ASAP

avoid large attitude changes to prevent eng flameout

14
Q

FUEL P in flight

low pressure

A
reduce collective	
fuel pump ON	
land ASAP
low power approach and landing 
BE PREPARED IN CASE OF AN ENGINE FLAME-OUT.
15
Q

FUEL FILTER continuously on (pre-clogged)
FUEL FILTER BY-PASS OPENING LEADS TO CONTAMINATION OF THE FUEL LINES AND THE GOVERNOR, WHICH MAY INDUCE N1 OSCILLATIONS, LIMITED POWER OR EVENTUALLY FLAME-OUT.

A
Fuel filter pre-clogging level 2 reached	
LAND ASAPL	
MONITOR N1 on VEMD
If N1 oscillations occur:	
LAND IMMEDIATELY
16
Q

FUEL FILTER

Flashing at idle or during starting or shut down

A

Fuel filter pre-clogging level 1 reached.

One flight of 3 hours maximum flight time can be performed before maintenance action

17
Q
LIMIT 
in high speed cruise or steep maneuvers:
Main servo unit maxload reached,
Max rotor head stress reached,
or extreme longitudinal control position
LIMIT may appear associated with HYD 1 in case of hydraulic failure
A

ReduceCollective
ReduceCyclic to reducespeed or load factor
continue flight

18
Q

LIMIT in rearward speed or hovering in high tail wind

LIMIT may appear associated with HYD 1 in case of hydraulic failure

A

Cyclic REDUCE rearward speed
Cyclic REDUCE tailwind component
continue flight

19
Q

PITOT

heat not operative

A

monitor airspeed indicator

continue flight

20
Q

HORN

aural warning not operative

A

check Horn ON
yes - failure
no - turn Horn ON
continue flight

21
Q

DOOR

one or both cargo doors unlocked

A

Airspeed to 70 kt
LAND ASAPL
Low rate of descent and approach

22
Q

INST LIGHT

one or both inst light circuits inop

A

CONTINUE FLIGHT

NOTE The dome light can be used as an additional instrument panel lighting.

23
Q

P2 OVHT
(temp > 90C in heating ducts)
Demisting function is degraded when P2 bleed is cut-off.

A
Press OFF on T Dial on ECS panel	
check P2 or P2S on VEMD	
after 1 min check P2 OVHT light
Light OFF	continue flight
Light ON	close P2 manual valve
Continue flight

In case that external visibility becomes significantly degraded LAND ASAP

24
Q

Eng Fire

A

Lower Collective
Airspeed 70 KIAS
autorotate

Emergency Fuel Shut Off Handle AFT
Check Fuel Pump OFF
Engine Start Selector OFF

after landing
BATT OFF
Rotor Brake ON below 170 rpm
evacuate and fight fire

25
Q

Engine Fire on Start

A
Engine Start Selector OFF	
Emerg Fuel Shut Off Handle AFT
Fuel Pump OFF	
Crank for 10 Sec	
BATT OFF	
Rotor Brake ON below 170 rpm	
Evacuate and fight fire
26
Q

RED GOV in flight

RED GOV LIGHT ILLUMINATES - MAJOR GOV FAIL
On VEHICLE page: FF and END
This failure can also result in loss of 􀀧􀀧N1 and torque parameters on the VEMD.

A

check flight parameters
EBCAU engages automatically and
Yellow Gov light illuminates

avoid abrupt collective pitch changes
maintain N1 >80% when Hp

27
Q

RED GOV on Start

RED GOV LIGHT ILLUMINATES. MAJOR GOV FAIL

A

Engine Start Selector OFF immediately

28
Q

YELLOW GOV - Continuously ON

Yellow GOV light illuminates minor FADEC failure
This failure can lead to a constant NR of 394 rpm. In this case tail rotor control margins are reduced.
Avoid hover with wind from left side and lateral flight to the left

A

avoid abrupt collective changes
maintain IAS below power off VNE
LAND ASAPL
on ground, do not start engine

29
Q

YELLOW GOV - flashing at idle or during start/shutdown

Yellow GOV light illuminates minor FADEC failure

A

Governor redundancy failure,
no impact on governing function

Start-up procedure: abort start,
see maintenance manual

autorotation training: cancel training, return to base